Why is my filament popping, I keep it in a dry box!?
You may not have given it much thought but the moisture absorbent (Silica gel) packs you have stashed inside your dry boxes to protect your 3D filament only work for a few months before they become saturated with moisture.
Continue reading “Recharge your Silica gel moisture absorbtion packs”
Have you been finding your 3D printer heated bed takes a long time to heat up? Been thinking about upgrading your power supply to a 24V or more seriously mains AC power? Have a go at this handy hack before you spend any money.
Continue reading “Speed up the heat up time of your 3D printer heated bed”
I’ve recently setup a Repetier Server to control my 3D printers, and wanted to be able to automatically upload Gcode from Simplify 3D into the server. Read on for instructions on how to set it up yourself.
Repetier Server, which if you haven’t heard of it, is like Octoprint, but designed to control multiple printers, has an easy GUI to configure your printers internal settings etc.
It is not completely the same however, it doesn’t have support for GPX (makerbot style gcode equivalent files), nor does it have a built in slicer, which I don’t mind as I use Simplify 3D anyway as part of my tool chain.
Continue reading “Automatically upload GCode from Simplify 3D to Repetier Server or Octoprint”
You might be tweaking your 3D settings to speed up your prints, trying to increase your printers jerk, acceleration, speed, more heat, tuning retraction, to get a faster print, but these all generally will push your machine closer to its limits and decrease your print quality.
This is where this tip comes in, I will show you how you can configure your infill layer height independently to be higher than your exterior surface, because really, who cares what your infill looks like, why have your printer meticulously laying down infill at 50 micron layer heights?
This technique works best when you are printing higher resolution prints (sub 0.1mm or less).
Continue reading “Speed up your 3D prints without sacrificing quality by changing your infill layer height”